The Voopoo Drag 6 is a 220W high-power vape mod with a 4400mAh integrated battery. Built for serious sub-ohm vapers who want a compact dual-battery-capacity device with the full range of power modes and a precision control wheel for wattage adjustment.

About the Voopoo Drag 6

Voopoo packed the Drag 6 with a 4400mAh built-in battery - the equivalent of two 2200mAh cells - in a body that measures 96.9 x 51.4 x 23.6mm. That is genuinely compact for a device at this power level. Output runs from 5W to 220W, powered by the GENE TT 3.0 chipset, which Voopoo developed specifically for high-wattage performance with fast fire response and accurate resistance detection.

The precision control wheel on the side is one of the Drag 6's standout features. Instead of pressing up/down buttons to step through wattage, you turn the wheel smoothly to your target number. It is faster and more intuitive, particularly when adjusting between different tanks or coil types. The 1.66-inch full-colour TFT screen is large enough to read wattage, resistance, battery percentage and mode comfortably at a glance.

Supported modes include Smart (auto-sets wattage from resistance), RBA (manual wattage), Temperature Control (stainless steel, titanium, nickel) and Memory (saves five custom settings). USB-C charging at 5V/3A fills it fully in approximately 95 minutes. 510-thread connection accepts any standard sub-ohm tank, RTA or RDA. Spring-loaded connector plate accommodates 25mm flush and 26mm tanks with minor overhang.

Specifications

• Dimensions: 96.9 x 51.4 x 23.6mm

• Battery: 4400mAh built-in (2 x 2200mAh)

• Output: 5-220W

• Chipset: GENE TT 3.0

• Display: 1.66-inch full-colour TFT

• Charging: USB-C, 5V/3A (approx. 95 minutes full charge)

• Connection: 510 thread (spring-loaded)

• Modes: Smart, RBA, TC (SS/Ti/Ni), Memory x5

What's in the Box

• 1 x Voopoo Drag 6 Mod

• 1 x USB-C Charging Cable

• 1 x User Manual

Resistance and Wattage Guide

For a standard 0.15 to 0.2 ohm dual-coil sub-ohm tank, the typical sweet spot is 60 to 100W depending on coil and personal preference. Single-coil mesh tanks at 0.2 to 0.4 ohm usually perform well at 40 to 70W. Use Smart mode to get an auto-suggested starting wattage for any coil, then adjust with the control wheel in 1W or 5W increments. TC mode on SS316L coils works well at 200 to 240°C for consistent flavour without risk of dry hits. The 220W ceiling exists for high-power RDA builds - most production coils will never need more than 100W.

Works with

• View all Voopoo mods at Southampton Vaping Centre

• Browse all mods and tanks